How To Paint A Banister
The concept is simple start with the underside of each banister then move to the sides and finish with the top of the banister.
How to paint a banister. A good primer will ensure better adhesion of paint to the surface and increases paint durability. We will see how these paints hold up over time. Use a fine paintbrush around the edges that meet with the stain and be extra careful to not get any paint on the stain. However you can t simply slap a couple of coats of paint over a varnished banister or any varnished surface and expect it to last.
How to brush a hand rail with latex paint and a paint brush. Banisters and handrails get a lot of use and over time varnish becomes rubbed worn and scratched. Next paint a coat of the primer onto your spindles. A simple method of brushing railing.
Brush the paint from the top of a spindle toward the bottom evenly on all sides. Begin painting at one end of the handrail starting that the top of the stairs. Scrape the banister handrail with a paint scraper to remove any bubbled loose or chipped paint. Paint each spindle of the banister starting at the top of the stairs and working downward.
Refinishing varnished wood is quite a lengthy task but painting it requires fewer steps. For each section of banister or railing apply a generous amount of paint along the center of the handrail then spread it along the length and width of it finally taking it around the side and bottom. Step 4 painting the banister 2 coats 2 hours. I know that the sw paint will following our diy painting tips because our kitchen cabinets and all the molding in our house has last for over 7 years with only a few minor scratches and blemishes.
Paint stair handrails and banisters. If you re nervous to paint the entire staircase a great way to get a pop of color or update dated stain is to paint just the handrails and banisters. Therefore we chose to use this colored enamel paint for the banister and my favorite white latex enamel sherwin williams proclassic for railings. House painting tips hacks.
If the existing paintwork is in poor condition use paint stripper instead of paper to remove old paint go over your stairs and banisters with a vacuum and a damp cloth to remove any dust and dirt then wipe dry. I will give you a few pointers laying out the paint so it will look. Next apply 1 2 coats of your semi gloss paint to each of your spindles working one section or about 10 spindles at a time. Sand the surface of the handrail with an 80 grit sanding sponge to remove any areas of paint left.
I m going to try hard to keep this g rated.