How To Sand A Banister
Step 3 tape spindles and newel posts.
How to sand a banister. To do this sand your banister lightly and use painter s tape to protect your walls. Time for me to sand it back to its original glory. Sand the stair railings with 100 grit sanding pads following the direction of the wood grain. This post is about how to use an electric sander to do the job.
Step 2 sand the banister. The problem is that it is covered in the old varnish that hadn t aged very well and was a horrible orange colour. If the banister is round wrap a piece of sandpaper around the banister so that it covers as much of the banister s surface as possible. Either way seal the banister with 1 3 coats of varnish and your banister will look great in no time.
With the sandpaper wrapped around it move the sandpaper back and forth as you move along the entire length. Vacuum thoroughly when you re done sanding. Sand any particularly rough spots with 120 grit sandpaper. It does not involve stripping the existing finish which will save you some time and create less mess.
Try to make the wood as smooth as possible and then wipe away any dust with a clean rag. This project is time consuming but definitely doable for anyone who likes to paint. The surface should be wiped with a tack cloth between sanding. If you d like you can paint sections of your banister after the stain is dry for a two toned look.
Once the banister has dried go over it with sandpaper to remove any stain or varnish that was not taken care of by the solvent. Start sanding with a medium grit sandpaper to remove light nicks and dents and the existing finish. Sand the banister at least three times switching to a finer grit with each pass. Reach any small or detailed areas with folded 100 grit sandpaper.
Sand with the grain and take the time to do a thorough job. Don a dust mask. Then paint 1 3 coats of stain over your entire banister. This video tutorial demonstrates how to stain a banister without sanding or stripping using general finishes gel stain and paint with water based primer and paint.
I chose a two toned look to match the.